When I did my last office setup, I got this monitor and I ran a lot of my USB devices through it. While it was functionally fine, there were three things that I was not a fan of:
- This monitor only charges my MacBook Pro at 65W.
- The USB ports were limited to 5 Gbps in terms of speed.
- The USB ports were limited to a max of 7.5W depending on the port.
Now I did highlight these in my review of the monitor. But I did want to address that and add some convenience to my setup. Thus after some research, I went to OWC’s website and ordered this.
This is the OWC Thunderbolt 5 Hub. I picked this hub because I wanted to future proof myself for when I replace my M1 Pro MacBook Pro with a newer model that supports Thunderbolt 5. Pictured above is the hub at the top. The power brick on the left along with a AC power cable at the bottom. Finally there’s a Thunderbolt 5 cable that’s 0.8M long and appears to be of very good quality. I do have a minor gripe about the power brick though. I would honestly have preferred that OWC took the approach that they did with the Thunderbolt Go Dock to integrate the power brick into the device. That would have made cable management a whole lot easier for me as I have a standing desk. Ideally, I would like to only to deal with cable managing one long cable as opposed to cable managing one cable and a power brick. But in the case of this hub, I had to account for the brick in both the standing and sitting positions that the desk offers. I eventually found a location on my desk for the hub, which in turn facilitated a route underneath my desk for the cable that allowed the brick to sit on the floor when the desk was in the sitting position, and have the brick slightly off the floor in the standing position. That’s not ideal, but it’s the best that I could come up with and I may revisit this at some point in the future to see if I can do better. Having said that, OWC might want to either rethink the brick as a whole, or make the cable with the barrel end connector that goes into the hub another foot longer to accommodate use cases like mine.
One thing that you will notice on the bottom of the power brick is a QR code that goes to OWC’s website where you will find any instructions that you need. There’s another just like it at the bottom of the hub itself. Bonus points to OWC for doing that as it reduces the chances that someone won’t RTFM and get into trouble as a result. Another thing that you will notice is that while the sides of the hub are aluminium, the top is made of plastic and is a bit of a fingerprint magnet.
On the back of the hub, you get a Kensington lock slot, the barrel connector for AC power, and three Thunderbolt 5 ports that do 80 Gbps bi-directionally, or 120 Gbps one way for video to say a 6K or 8K monitor. The one on the left goes to your computer and can charge it at 140W. The port next to it is where I plugged my monitor into which has this webcam, this light, and this card reader plugged into it. The port on the right is where I plugged in these speakers which allowed me to get rid of an audio cable and a USB power adapter in the process as the Thunderbolt 5 ports provide power. Plus because the speakers are now plugged into a Thunderbolt 5 port, the sound that they produce is marginally better. That’s a win right there as I get better sound and I have to deal with one less cable to manage along with having to use one less power adapter.
When it comes to monitors, the hub supports:
- Up to three 8K monitors @ 60Hz
- or two 8K monitors @ 120Hz
- or three 4K monitors @ 144Hz
All of that assumes you have a Mac or PC with Thunderbolt 5. But I had no issue running my 4K monitor at 144 Hz or at an adaptive refresh rate of up to 120 Hz on my MacBook Pro which has Thunderbolt 4. In case you’re wondering what the holes are above the Thunderbolt 5 ports, they’re for OWC ClingOn cable stabilizer mounts which you can use to help prevent accidental cable disconnections. Those need to be purchased separately.
Now to the front of the hub where you get a USB-A 3.2 Gen 2 port that does 10 Gbps and a Thunderbolt 5 port. By having these ports on the front makes life easy for me in terms of when I need to plug in a device like a hard drive. Speaking of hard drives, I tested the speed of this hub by using this OWC hard drive. Here’s what I got:
These speeds are pretty close to the speeds that I got when I tested the same drive directly connected to my MacBook Pro. Thus I have no complaints here.
On the left side is a power button that’s flush with the rest of the hub’s case. Thus the possibility of accidental presses is basically eliminated.
On the bottom are lights that indicate the power status and Thunderbolt connectivity. It’s cool that they put these lights on the bottom as they don’t add to the light pollution that exists in my home office because of my various devices having LED lights that I can’t easily disable or hide.
Setting up the hub was pretty easy as I literally plugged everything in and was up and running in minutes. The only thing that I did not do was install the OWC Dock Ejector software. Now while I do have an Apple SuperDrive kicking around, I have not used it to burn a CD or DVD in years other than to test an OWC product. I should note that the Dock Ejector software has been completely rewritten to address what I had noticed when I reviewed the Thunderbolt Go Dock. Also, you don’t need to have an OWC dock or hub to use it as it will eject anything (disks and the like) from any vendor. More details on this latest version of OWC Dock Ejector can be found here.
Here’s the hub in place and in operation. Yes I will get around to cleaning up the cabling as I am not a fan of it either as it looks messy.
In daily usage, the hub never got anything other than warm to the touch, and I have had no issues in terms of plugging devices in and having them available for use. And I guess I should answer why I went the hub route rather than getting a dock with even more ports. Simply put, it was overkill for my needs as docks typically have things like Ethernet, card readers and the like built in. I already have a card reader and none of my computers use Ethernet. So the hub is the best way to go for me. While it would have been nice to have one more Thunderbolt 5 port on this hub, I could always daisy chain another hub with this one to get more ports.
The OWC Thunderbolt 5 Hub goes for $189 USD. Though I will note that OWC does put them on sale from time to time. This hub is a welcome addition to my office setup and frankly, I should have gotten it sooner as it solved a number of irritants that I had with my setup. Thus making my setup much more functional for me.